• Re-enter the new password to confirm it.
Changing the password of the administrators using the supervisor
msh> passwd {Administrator ID}
• Enter the new password.
• Re-enter the new password to confirm it.
• Be sure not to forget or lose the password.
• The
password can be entered using up to 32 alphanumeric characters. Characters are case-sensitive.
For example, "R" is not the same as "r".
pathmtu
Use the "pathmtu" command to display and configure the PathMTU Discovery service function.
View settings
msh> pathmtu
Configuration
msh> pathmtu {on|off}
• The default is "on".
• If the MTU size of the sent data is larger than the router's MTU, the router will declare it
impassable, and communication will fail. If this happens, setting "pathmtu" to "off" optimizes the
MTU size and prevents data output failure.
• Depending on the environment, information might not be obtained from the router, and
communication will fail. If this happens, set "pathmtu" to "off".
prnlog
Use the "prnlog" command to obtain printer log information.
Print logs display
msh> prnlog
• Displays 16 previous print jobs.
msh> prnlog "ID Number"
• Specify the ID number of the displayed print log information to display additional details about
a print job.
• For details about displayed contents, see "Getting Printer Information over the Network".
2. Remote Maintenance Using telnet
58
To Next Page
Loading...
Need help?
General