Using NetWare
This section describes the setting procedure for network printers in the NetWare environment. In the
NetWare environment, you can connect the printer as a "print server" or "remote printer".
• IPv6 cannot be used on this function.
• This
procedure assumes an environment is already prepared for normal NetWare running the printing
service setting.
• The procedure is explained with the following example settings:
• File server name ...CAREE
• Print server name ...PSERV
• Printer name ...R-PRN
• Queue name ...R-QUEUE
Setting Up as a Print Server (NetWare 3.x)
Follow the procedure below to connect the printer as a print server using NetWare 3.x.
1. Log in to Web Image Monitor as an administrator.
For details about logging in, see p.143 "Access in the Administrator Mode".
2. Click [Configuration] in the menu area, and then click [NetWare Print Settings].
•
Print Server Name: Enter the NetWare print server name. To use the interface board as a print
server, enter the name of a print server that is not active on the file server. Use up to 47 characters.
• Logon Mode: Specify whether to designate a file server or NDS tree when logging in to
NetWare.
• File Server Name: When a file server name is entered here, only the specified file server is
searched for. This item is mandatory. Use up to 47 characters.
• NDS Tree: To enable NDS mode, enter the name of the NDS tree you want to log in to. Use up
to 32 alphanumeric characters.
• NDS Context Name: To enable NDS mode, enter the print server context. Use up to 127
characters.
• Operation Mode: Specify whether to use the interface board as a print server or a remote printer.
• Remote Printer No.: This item is effective when the interface board is specified as a remote printer.
Enter the same number as the number of the printer to be created on the print server (0 to 254
characters).
6. Using a Printer Server
158
To Next Page
Loading...
Need help?
General