If you select [Simple (All)], you can print even with unauthenticated printer drivers or devices. Specify this
setting if you want to print with a printer driver or device that cannot be identified by the printer or if you
do not require authentication for printing. However, note that, because the printer does not require
authentication in this case, it may be used by unauthorized users.
1. Select [Available Functions].
Select [Black & White] or [PC Control] when enabling printing.
2. Click [OK].
3. Click [Logout].
4. Close Web Image Monitor.
Selecting Simple (Limitation)
If you select [Simple (Limitation)], you can specify clients for which printer job authentication is not required.
Specify [Parallel Interface (Simple)], [USB (Simple)] and the clients' IPv4 address range in which printer
job authentication is not required. Specify this setting if you want to print using unauthenticated printer
drivers or without any printer driver. Authentication is required for printing with non-specified devices.
1. Select [Simple (Limitation)], and enter [Limitation Range].
Specify the range in which [Simple (Limitation)] is applied to "Printer Job Authentication".
If you specify IPv4 or IPv6 address range, proceed to step 2.
If you specify [Parallel Interface (Simple)], proceed to step 3.
If you specify [USB (Simple)], proceed to step 4.
2. Select [IPv4 Address 1], [IPv4 Address 2], [IPv4 Address 3], [IPv4 Address 4], or [IPv4
Address 5] and then enter the IPv4 address on the "Limitation Range (IPv4)" area.
Be sure the number you enter for End IPv4 Address is larger than that for Start IPv4 Address.
If you want to use IPv6, specify the IPv6 address in the "Limitation Range (IPv6)" area.
3. Select [Apply] in the "Parallel Interface (Simple)" area.
4. Select [Apply] in the "USB (Simple)" area.
5. Click [OK].
6. Click [Logout].
7. Close Web Image Monitor.
3. Configuring User Authentication
32
To Next Page
Loading...
Need help?
General