• If you do not use NIS or DNS, you must manually enter the IP address and host name of each
workstation using the network printer in the /etc/hosts file.
Registering the printer
The installation shell script registers the printer as a remote printer following the procedure below:
1. Stop the scheduler.
/usr/lib/lpshut
2. Register the printer.
/usr/lib/lpadmin -Pnp -v/dev/null -mrmodel
-ormnphost -orpoption -ob3
• np is the printer name, nphost is the host name.
For details about "option", see "Specifying the Device Option".
"lp" will be assigned, if the option is not used.
3. Set the printer so the print job is listed in the print queue.
/usr/lib/accept np
4. Set the printer to perform the print job.
/usr/lib/enable np
5. Restart the scheduler.
/usr/lib/lpsched
• p.21 "Specifying the Device Option"
Using the Installation Shell Script
15
To Next Page
Loading...
Need help?
General