add_sess_IPv6: community <community name> already defined.
The same community name already exists. Use another community name.
add_sess_IPX: bad trap addr :<IPX address>, community:<community name>
The IPX address (00:00:00:00:00:00) is unavailable when the community access type is TRAP. Specify
the host IPX address for the TRAP destination.
add_sess_IPX: community <community name> already defined.
The same community name already exists. Use another community name.
adjust time server <NTP server> offset:xx sec.
ncsd tells you the timing of the NTP server and whether or not the time system clock is set.
• NTP Server: NTP server name
• offset: number of seconds of delay (minus number if a time in advance is specified)
Attach FileServer =<file server>
Connection to the file server as the nearest server has been established.
Attach to print queue <print queue name>
The system connects to the print queue when the print server goes online.
authenticating
The supplicant is authenticating with the access point (EAP or WPA).
authentication mode mismatch
The authentication mode of the access point is different from the authentication mode of the supplicant.
Use the same authentication mode between the access point and the supplicant.
authenticated
The supplicant has been authenticated.
The authentication was successful. If authentication is successful, this message always appears at the end
of the process.
centrod is disabled.
Parallel communication could not be established. Enable "centrod" in the security mode setting.
child process exec error! (process name)
The network service failed to start. Turn the printer off and then on. If this does not work, contact your service
or sales representative.
cipher suite mismatch
The uni-cast / multi-cast suite (TKIP/AES/WEP) of the access point is different from the suite used by the
supplicant.
2. Remote Maintenance Using telnet
98
To Next Page
Loading...
Need help?
General