• You can confirm that the SD card was installed correctly by checking the control panel menu.
Depending on the SD card, certain menu items appear on the display.
• SD card supplied with the optional hard disk (Type 1 model only): Make sure [Machine Data
Encryption] appears in [Security Options]. Depending on settings, [Machine Data Encryption]
might not appear. For details about how to confirm this setting, consult your administrator.
• IPDS card: Make sure [IPDS Menu] appears under [Print Settings].
• NetWare card: Make sure [NetWare] appears in [Effective Protocol] under [Network].
• ELP-NX card: Press the [Switch Functions] key, and then confirm that ELP-NX appears in
[JavaTM/X].
• If the card is not installed properly, repeat the procedure from the beginning. If it cannot be installed
correctly even after reattempting installation, contact your sales or service representative.
• For details about printing the configuration page, see p.44 "Test Printing".
3. Installing Options
68
To Next Page
Loading...
Need help?
General