4. Press the [ ] or [ ] key to select [Effective Protocol], and then press the [OK] key.
5. Press
the [
] or [ ] key to select the appropriate network protocol, and then press the [OK]
key.
6. Press the [ ] or [ ] key to select [Active] or [Inactive], and then press the [OK] key.
Set other protocols you need to set in the same way.
•
Select [Inactive] for unused protocols.
• Enable IPv4 to use the pure IPv4 environment of NetWare5/5.1, NetWare 6/6.5.
7. Press the [Escape] key until the screen returns to the [Network] menu.
8. If you use IPv4, assign the IPv4 address to the printer. Press the [
] or [ ] key to select
[Machine IPv4 Address], and then press the [OK] key.
To get the IP address for the printer, consult your network administrator.
9. To specify the IP Address, press [IP Add.].
If you use IPv4, also assign the subnet mask and gateway address. To assign these, press [Subnet M]
or [Gateway].
Ethernet Configuration
77
To Next Page
Loading...
Need help?
General