EasyManuals Logo
Home>Rockwell Automation>Adapter>PowerFlex 755 Drive

Rockwell Automation PowerFlex 755 Drive User Manual

Rockwell Automation PowerFlex 755 Drive
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
3-16 Configuring the Adapter
PowerFlex® 755 Drive Embedded EtherNet/IP Adapter User Manual
Publication 750COM-UM001A-EN-P
Setting Web Access Control
By using a web browser to access the IP address set for the adapter, you
can view the adapter’s web pages for information about the adapter, the
drive, and other DPI devices connected to the drive, such as HIMs or
converters. Additionally, the adapter can be configured to automatically
send e-mail messages to desired addresses when selected drive faults
occur and/or are cleared, and/or when the adapter takes a
communication or idle fault action. For more details on the adapter’s
web pages, refer to Chapter
8, Viewing the Adapter Web Pages.
By default, the adapter web pages are disabled. To enable the adapter
web pages, set Parameter 52 - [Web Enable] to “1” (Enabled) and
then reset the adapter for the change to take effect.
Figure 3.17 Edit Web Enable HIM Screen
Bit 0 of Parameter 53 - [Web Features] is used to protect the
configured settings for e-mail messaging. By default, settings are not
protected and the user can make changes. To protect the configured
settings, set the value of E-mail Cfg Bit 0 to “0” (Disabled). You can
unprotect the configuration by changing Bit 0 back to “1” (Enabled).
E-mail messaging will always remain active regardless of whether or
not its settings are protected—unless e-mail messaging was never
configured. For more information about configuring adapter e-mail
messaging or to stop e-mail messages, refer to Configure E-mail
Notification Web Page on page 8-6.
Figure 3.18 Edit Web Features HIM Screen
Bit 0 is the right-most bit. In Figure 3.18 it equals “1” (Enabled).
Changes to this parameter take effect immediately. A reset is not
required.
Value Description
0 Disabled (Default)
1 Enabled
ESC
ENTER
Stopped
0.00 Hz
AUTO
F
▲▼
Edit Web Enable
Disabled 0
0<<1
Bit Description
0 E-mail Cfg (Default = 1 = Enabled)
1 - 15 Not Used
ESC ENTER
Stopped
0.00 Hz
AUTO
F
WX
Edit Web Features
xxxx xxxx xxxx xxx1
E-mail Cfg

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rockwell Automation PowerFlex 755 Drive and is the answer not in the manual?

Rockwell Automation PowerFlex 755 Drive Specifications

General IconGeneral
BrandRockwell Automation
ModelPowerFlex 755 Drive
CategoryAdapter
LanguageEnglish

Related product manuals