3-64 ENGINE
• Install the snap ring
1 completely with the special tool.
" 09900-06107: Snap ring pliers
#
STARTER TORQUE LIMITER
STARTER TORQUE LIMITER INSPECTION
#
• Check the slip torque with the special tools.
" 09930-73110: Starter torque limiter holder
1
09930-73120: Starter torque limiter socket
2
& Slip torque
Standard: 20 – 45 N·m
(2.0 – 4.5 kgf-m, 14.5 – 32.5 lb-ft)
• Set the starter torque limiter to the special tools and vise as
shown in the illustration.
• If the slip torque is not within the specification, replace the
starter torque limiter with a new one.
* Never reuse a snap ring.
* When installing a new snap ring, care must be taken
not to expand the end gap larger than required to slip
a snap ring over the gear.
* After installing a snap ring, always insure that it is
completely seated in its groove and securely fitted.
Do not attempt to disassemble the starter torque lim-
iter.
The starter torque limiter is available only as an
assembly.
To Next Page
Loading...
Need help?
General
