CHASSIS 6-85
VALVE
• Inspect the valve after the tire is removed from the rim.
Replace the valve with a new one if the seal rubber is peeling
or has damage.
• Inspect the valve core. If the seal has abnormal deformation,
replace the valve with a new one.
VALVE INSTALLATION
• Any dust or rust around the valve hole must be cleaned off.
Then install the valve in the rim.
NOTE:
To properly install the valve into the valve hole, apply a special
tire lubricant or neutral soapy liquid to the valve.
"
TIRE INSTALLATION
• Apply tire lubricant to the tire bead.
• When installing the tire onto the wheel, observe the following
points.
"
Seal
Be careful not to damage the lip of valve.
Valve hole
Wheel
Valve lip
Valve
* Do not reuse the valve which has been once
removed.
* Do not use oil, grease or gasoline on the tire bead in
place of tire lubricant.
To Next Page
Loading...
Need help?
General
