6-66 CHASSIS
REAR BRAKE
CONSTRUCTION
(
"
* This brake system is filled with an ethylene glycol-based DOT 4 brake fluid. Do not use or mix
different types of fluid such as silicone-based or petroleum-based.
* Do not use any brake fluid taken from old, used or unsealed containers. Never reuse brake
fluid left over from the last servicing or stored for long periods.
* When storing the brake fluid, seal the container completely and keep away from children.
* When replenishing brake fluid, take care not to get dust into fluid.
* When washing brake components, use fresh brake fluid. Never use cleaning solvent.
* A contaminated brake disc or brake pad reduces braking performance. Discard contaminated
pads and clean the disc with high quality brake cleaner or neutral detergent.
Handle brake fluid with care: the fluid reacts chemically with paint, plastics, rubber materials
etc. and will damage them severly.
ITEM N·m kgf.m lb-ft
A
23 2.3 16.5
B
10 1.0 7.0
C
18 1.8 13.0
D
7.5 0.75 5.5
E
23 2.3 16.5
F
17 1.7 12.5
G
27 2.7 19.5
H
2.5 0.25 1.8
@
1
Brake hose
2
Diaphragm
3
Reservoir tank hose
4
Piston/cup set
5
Push rod
6
Dust boot
7
Piston seal
8
Dust seal
9
Piston
0
Pad shim
A
Pad insulator
B
Brake pad
C
Brake pad spring
D
Caliper bracket
E
Caliper
A
Brake hose union bolt
B
Rear brake master cylinder mounting
C
Rear brake master cylinder rod lock nut
D
Air bleeder valve
E
Brake caliper mounting bolt
F
Pad mounting pin
G
Brake caliper sliding pin
H
Plug
To Next Page
Loading...
Need help?
General
