CHASSIS 6-73
• Install the caliper to the caliper bracket
1.
• Set the boot onto the sliding pin securely.
• Install the brake pad. (!6-67)
• Tighten the brake hose union bolt with the brake hose union
pipe seated in the cutout on the caliper.
(Rear brake hose routing: !8-25)
& Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
"
MASTER CYLINDER REMOVAL AND DISAS-
SEMBLY
• Drain the brake fluid. (!6-68)
• Remove the brake fluid reservoir tank mounting bolt
1.
• Loosen the lock nut
2.
• Remove the master cylinder mounting bolts
3.
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the cal-
iper. (! 2-24)
To Next Page
Loading...
Need help?
General
