FI SYSTEM 4-77
HO2 SENSOR REMOVAL/INSTALLATION
• Remove the engine under cover.
• Disconnect the HO
2
sensor lead wire couplers.
• Remove the HO
2
sensor unit.
$
"
• Installation is in the reverse order of removal.
"
• Tighten the sensor unit to the specified torque.
' HO
2
SENSOR: 47.5 N·m (4.75 kgf-m, 34.3 lb-ft)
• Route the HO
2
sensor lead wire into the frame. (# 8-16)
• Connect the HO
2
sensor couplers.
Do not remove the HO
2
sensor while it is hot.
Be careful not to expose it to excessive shock.
Do not use an impact wrench while removing or
installing the HO
2
sensor unit.
Be careful not to twist or damage the sensor lead wire.
Do not apply oil or other materials to the sensor air
hole.
To Next Page
Loading...
Need help?
General
