ELECTRICAL SYSTEM 7-33
BATTERY
SPECIFICATIONS
INITIAL CHARGING
Filling electrolyte
• Remove the aluminum tape
1 sealing the battery electrolyte
filler holes.
NOTE:
When filling electrolyte, the battery must be removed from the
vehicle and must be put on the level ground.
• Remove the caps
2.
NOTE:
* After filling the electrolyte completely, use the removed cap
2
as the sealed caps of battery-filler holes.
* Do not remove or pierce the sealed areas
3 of the electrolyte
container.
• Insert the nozzles of the electrolyte container into the battery’s
electrolyte filler holes, holding the container firmly so that it
does not fall. Take precaution not to allow any of the fluid to
spill.
• Make sure air bubbles are coming up each electrolyte con-
tainer, and leave in this position for about more than 20 min-
utes.
Type designation FTX14-BS
Capacity 12 V, 43.2 kC (12 Ah)/10 HR
To Next Page
Loading...
Need help?
General
