PERIODIC MAINTENANCE 2-17
COOLING SYSTEM
ENGINE COOLANT LEVEL CHECK
• Keep the motorcycle upright.
• Check the engine coolant level by observing the full and lower
lines on the engine coolant reserve tank.
A Full line
B Lower line
• If the level is below the lower line, add engine coolant to the
full line from the engine coolant reserve tank filler. To remove
the filler cap, remove the right fuel tank side cover. (! 6-4)
ENGINE COOLANT CHANGE
• Remove the right fuel tank side cover. (!6-4)
• Remove the radiator cap
1.
• Drain engine coolant by removing the drain bolts
A and
B.
#
• Flush the radiator with fresh water if necessary.
• Tighten the water drain bolts
A and
B to the specified torque.
& Water drain bolt
A: 13 N·m (1.3 kgf-m, 9.5 lb-ft)
B: 5.5 N·m (0.55 kgf-m, 4.0 lb-ft)
• Pour the specified engine coolant up to the radiator inlet.
• Bleed the air from the engine coolant circuit as following pro-
cedure.
NOTE:
For engine coolant information, refer to page 5-2.
Inspect every 6 000 km (4 000 miles, 6 months).
Replace engine coolant every 2 years.
* Do not open the radiator cap when the engine is hot,
as you may be injured by escaping hot liquid or
vapor.
* Engine coolant may be harmful if swallowed or if it
comes in contact with skin or eyes. If engine coolant
gets into the eyes or in contact with the skin, flush
thoroughly with plenty of water. If swallowed, induce
vomiting and call physician immediately!
To Next Page
Loading...
Need help?
General
