ENGINE 3-65
STARTER CLUTCH
DISASSEMBLY
• Remove the starter clutch securing bolts by holding the rotor
with the special tool.
" 09930-44541: Rotor holder
REASSEMBLY
• Install the starter clutch in the proper direction.
NOTE:
* When installing the starter clutch onto the rotor, face the
flange side
A of the one way clutch to the rotor.
* The arrow mark
B must face to the engine side.
• Apply engine oil to the starter clutch.
• Apply THREAD LOCK SUPER “1303” to the bolts, and then
tighten them to the specified torque with the special tool.
$ Starter clutch bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
* 99000-32030: THREAD LOCK SUPER “1303”
" 09930-44541: Rotor holder
INSPECTION
• Install the starter driven gear to the starter clutch.
• Check that the starter driven gear turns in the opposite direc-
tion of the arrow mark
C on the rotor while holding the gener-
ator rotor. The gear never turns in the direction of the arrow.
• If there is anything unusual, replace the one way clutch.
Inspect the starter driven gear bushing for any damage.
To Next Page
Loading...
Need help?
General
