6-44 CHASSIS
INSPECTION
Inspect the shock absorber body and bushing for damage and
oil leakage.
If any defects are found, replace the shock absorber with a new
one.
"
REAR SHOCK ABSORBER DISPOSAL
(
GAS PRESSURE RELEASE
• Mark the drill hole at
A, shown in the illustration, with a center
punch.
• Cover the rear shock absorber with a transparent vinyl bag
1.
• Hold the rear shock absorber
2 with a vice.
• Make a hole with a 3 mm drill.
(
Do not attempt to disassemble the rear shock
absorber unit. It is unserviceable.
The rear shock unit contains high-pressure nitrogen
gas. Mishandling can cause explosion.
* Keep away from fire and heat. High gas pressure
caused by heat can cause an explosion.
* Release gas pressure before disposing.
7 mm
(0.27 in)
Wear eye protection to protect your eyes from
released gas and metal chips.
To Next Page
Loading...
Need help?
General
