6-74 CHASSIS
• Place a rag underneath the union bolt on the master cylinder
to catch spilled drops of brake fluid. Remove the union bolt
4
and disconnect the brake hose.
• Disconnect the reservoir tank hose.
"
• Remove the master cylinder by turning the master cylinder
rod.
• Disconnect the reservoir hose.
• Remove the connector
5 by removing the snap ring
6.
• Remove the O-ring
7.
"
• Pull out the dust boot
8, then remove the snap ring
9.
• Remove the push rod, piston/primary cup and spring.
MASTER CYLINDER INSPECTION
CYLINDER, PISTON AND CUP SET
Inspect the cylinder bore wall for any scratches or other dam-
age.
Inspect the cup set and each rubber part for damage.
Immediately and completely wipe off any brake fluid
contacting any parts of the motorcycle. The fluid
reacts chemically with paint, plastic and rubber mate-
rials, etc. and will damage them severely.
Replace the O-ring with a new one.
To Next Page
Loading...
Need help?
General
