PERIODIC MAINTENANCE 2-27
CHASSIS BOLT AND NUT
Check that all chassis bolts and nuts are tightened to their specified torque. (Refer to page 2-28 for the loca-
tions of the following nuts and bolts on the motorcycle.)
Tighten initially at 1 000 km (600 miles, 1 month) and
every 6 000 km (4 000 miles, 6 months) thereafter.
ITEM N·m kgf-m lb-ft
1 Steering stem head nut 90 9.0 65.0
2 Steering stem locknut 80 8.0 58.0
3 Front fork upper clamp bolt 23 2.3 16.5
4 Front fork lower clamp bolt 23 2.3 16.5
5 Front axle 100 10.0 72.5
6 Front axle pinch bolt 23 2.3 16.5
7 Handlebar holder bolt 23 2.3 16.5
8 Handlebar holder set nut 45 4.5 32.5
9 Front brake master cylinder mounting bolt 10 1.0 7.0
0 Front brake caliper mounting bolt 39 3.9 28.0
A Brake hose union bolt 23 2.3 16.5
B Clutch master cylinder mounting bolt 10 1.0 7.0
C Clutch hose union bolt 23 2.3 16.5
D Air bleeder valve 7.5 0.75 5.5
E Brake disc bolt (Front & Rear) 23 2.3 16.5
F Rear brake caliper mounting bolt 23 2.3 16.5
G Rear brake master cylinder mounting bolt 10 1.0 7.0
H Rear brake master cylinder rod locknut 18 1.8 13.0
I Front footrest bracket mounting bolt 26 2.6 19.0
J Swingarm pivot nut 100 10.0 72.5
K Swingarm pivot shaft locknut 90 9.0 65.0
L Rear shock absorber mounting nut
(Upper & Lower)
50 5.0 36.0
M Cusion lever mounting nut 78 7.8 56.5
N Cusion lever rod mounting nut 78 7.8 56.5
O Rear axle nut 100 10.0 72.5
P Seat rail bolt 55 5.5 40.0
To Next Page
Loading...
Need help?
General
