To Next Page

To Previous Page

6-10 CHASSIS

• Remove the dust seal by using the oil seal remover.

# 09913-50121: Oil seal remover

FRONT AXLE

Using a dial gauge, check the front axle for runout and replace it

if the runout exceeds the limit.

# 09900-20607: Dial gauge (1/100)

09900-20701: Magnetic stand

09900-21304: V-block set (100 mm)

$ Axle shaft runout

Service Limit: 0.25 mm (0.010 in)

WHEEL

Make sure that the wheel runout checked as shown does not

exceed the service limit. An excessive runout is usually due to

worn or loosened wheel bearings and can be reduced by replac-

ing the bearings. If bearing replacement fails to reduce the

runout, replace the wheel.

(Wheel inspection: !6-84)

$ Wheel runout

Service Limit (Axial and Radial): 2.0 mm (0.08 in)

WHEEL BEARING

Inspect the play of the wheel bearings by finger while they are in

the wheel. Rotate the inner race by finger to inspect for abnor-

mal noise and smooth rotation.

Replace the bearing in the following procedure if there is any-

thing unusual.

• Remove the wheel bearings by using the special tool.

# 09921-20240: Bearing remover set

Do not reuse the removed dust seals.

Do not reuse the removed bearings.

Suzuki DL1000 Service Manual

Other manuals for Suzuki DL1000