Suzuki DL1000 Service Manual

CHASSIS 6-53
SWINGARM BEARING
• Install the bearings and spacer into the swingarm pivot all
together by using the special tool.
# 09941-34513: Steering race installer
NOTE:
When installing the bearing, the stamped mark on the bearing
must face the special tool.
• Install the cushion rod bearing with the special tool.
# 09941-34513: Steering race installer
NOTE:
When installing the bearing, the dust seal that is embedded in
the bearing must face outside.
CUSHION LEVER BEARING
• Press the bearings into the cushion lever with the special tool.
# 09941-34513: Steering race installer
NOTE:
When installing the bearing, the dust seal that is embedded in
the bearing must face outside.
• Apply grease to the bearings and spacers.
% 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)

Suzuki DL1000 Specifications

General

Displacement	996cc
Compression Ratio	11.3:1
Final Drive	Chain
Starter	Electric
Bore x Stroke	98.0mm x 66.0mm
Transmission	6-speed
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Fuel Tank Capacity	22.0 L (5.8 US gal)
Ground Clearance	165 mm (6.5 in)
Ignition	Electronic
Fuel System	Electronic Fuel Injection