6-76 CHASSIS
• Install the reservoir tank and reservoir tank hose. (Rear brake
hose routing: !8-25)
• Temporarily install the master cylinder to the frame.
• Connect the brake hose to the master cylinder. (Rear brake
hose routing: !8-25)
• Tighten the brake hose union bolt to the specified torque.
& Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
"
• Adjust the brake pedal height. (!2-23)
• Reinstall the master cylinder.
• Tighten the master cylinder mounting bolts to the specified
torque.
& Rear master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the
master cylinder. (!2-24)
To Next Page
Loading...
Need help?
General
