AudioCodes Mediant 500L MSBR User Manual

User's Manual 67. Configuration Parameters Reference
Version 6.8 1029 Mediant 500L MSBR
Parameter Description

[-1] = Never expires.

[0]
= Each request requires RADIUS authentication.
Web: RADIUS VSA Vendor ID
CLI: vsa-vendor-id
[RadiusVSAVendorID]
Defines the vendor ID that the device accepts when parsing a
RADIUS response packet.
The valid range is 0 to 0xFFFFFFFF. The default is 5003.
Web: RADIUS VSA Access
Level Attribute
CLI: vsa-access-level
[RadiusVSAAccessAttribute]
Defines the code that indicates the access level attribute in the
Vendor Specific Attributes (VSA) section of the received RADIUS
packet.
The valid range is 0 to 255. The default is 35.
[MaxRADIUSSessions]
Defines the number of concurrent calls that can communicate with
the RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
EMS: RADIUS Auth Number
of Retries
[RADIUSRetransmission]
Defines the number of retransmission retries.
The valid range is 1 to 10. The default is 3.
[RadiusTO]
Defines the time interval (measured in seconds) that the device
waits for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default is 10.
67.14.2.3 LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
Table 67-76: LDAP Parameters
Parameter Description
Web: LDAP Service
CLI: configure voip/ldap/enable
[LDAPServiceEnable]
Enables the LDAP feature.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is
required.
CLI: search-dns-in-parallel
[LDAPSearchDNsinParallel]
Defines the method of how the device queries the DN
object within each LDAP server.
 [0] Sequential = (Default) The query is done in each
DN object, one by one, until a result is returned.
 [1] Parallel = The query is done in all DN objects at the
same time.
Web: LDAP Search Server Method
CLI: ldap-search-server-method
[LDAPSearchServerMethod]
Defines the method of how the device queries between
two LDAP severs.
 [0] Sequential = The device first queries one of the
LDAP servers, and if the DN object is not found, it
queries the second LDAP server.
 [1] Parallel = (Default) The device queries the LDAP
servers at the same time.
Web: LDAP Authentication Filter
CLI: configure voip > ldap > auth-filter
Defines the LDAP search filter attribute for searching the
login username in the directory's subtree for LDAP-based

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English