AudioCodes Mediant 500L MSBR User Manual

User's Manual 29. Configuring Supplementary Services
Version 6.8 443 Mediant 500L MSBR

SuppServCodeCFNRDeact - Call Forward on No Reply Deactivation
Note: These codes must be defined according to the settings of the softswitch (i.e.,
the softswitch must recognize them).
Below is an example of an INVITE message sent by the device indicating an unconditional
call forward (“*72”) to extension number 100. This code is defined using the
SuppServCodeCFU parameter.
INVITE sip:*72100@10.33.8.53;user=phone SIP/2.0
Via: SIP/2.0/UDP 10.33.2.5:5060;branch=z9hG4bKWDSUKUHWFEXQSVOUVJGM
From: <sip:400@10.33.2.5;user=phone>;tag=DUOROSXSOYJJLNBFRQTG
To: <sip:*72100@10.33.8.53;user=phone>
Call-ID: GMNOVQRRXUUCYCQSFAHS@10.33.2.5
CSeq: 1 INVITE
Contact: <sip:400@10.33.2.5:5060>
Supported: em,100rel,timer,replaces
Allow:
REGISTER,OPTIONS,INVITE,ACK,CANCEL,BYE,NOTIFY,PRACK,REFER,INFO,SUB
SCRIBE
User-Agent: Sip Message Generator V1.0.0.5
User-to-User: 31323334;pd=4
Content-Type: application/sdp
Content-Length: 155
You can also enable the device to indicate the type of CF service in the Request-URI of the
outgoing SIP INVITE message. Upon receipt of an ISDN Facility message for call forward
(Diversion) from the BRI phone, the device indicates the call forwarding service in the
Request-URI header using a proprietary parameter “facility=<call forward service>”, where
call forward service can be one of the following:

“cfu-activate”: Call Forwarding Unconditional activated

“cfu-deactivate”: Call Forwarding Unconditional deactivated

“cfb-activate”: Call Forward on Busy activated

“cfb-deactivate”: Call Forward on Busy deactivated

“cfnr-activate”: Call Forward on No Reply activated

“cfnr-deactivate”: Call Forward on No Reply deactivated
For example:
INVITE sip:400@10.33.2.48;user=phone;facility=cfu-activate SIP/2.0
To enable the feature, configure the UseFacilityInRequest ini file parameter to 1.
29.7 Call Waiting
The Call Waiting feature enables FXS devices to accept an additional (second) call on
busy endpoints. If an incoming IP call is designated to a busy port, the called party hears a
call waiting tone (several configurable short beeps) and (for Bellcore and ETSI Caller IDs)
can view the Caller ID string of the incoming call. The calling party hears a call waiting
ringback tone. The called party can accept the new call using hook-flash, and can toggle
between the two calls.
 To enable call waiting:
1. Set the parameter EnableCallWaiting to 1.
2. Set the parameter EnableHold to 1.

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English