AudioCodes Mediant 500L MSBR User Manual

User's Manual 4. Configuring VoIP LAN Interface for OAMP
Version 6.8 33 Mediant 500L MSBR
4 Configuring VoIP LAN Interface for OAMP
You can change the IP address of the VoIP-LAN interface for OAMP, using any of the
following methods:

Embedded HTTP/S-based Web server - see ''Web Interface'' on page 33

Embedded command line interface (CLI) - see ''CLI'' on page 34
4.1 Web Interface
The following procedure describes how to change the IP address of the OAMP on the
VoIP-LAN interface, using the Web-based management tool (Web interface). The default
IP address is used to initially access the device.
 To configure the VoIP-LAN IP Address for OAMP, using the Web interface:
1. Connect Port 1 (left-most LAN port) located on the front panel directly to the network
interface of your computer, using a straight-through Ethernet cable.
2. Make sure that your computer is configured to automatically obtain an IP address. The
device has an embedded DHCP server, which by default allocates IP addresses to
connected computers.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the
default IP address of the device; the Web interface's Web Login screen appears:
Figure 4-1: Web Login Screen
b. In the 'Username' and 'Password' fields, enter the case-sensitive, default login
username ("Admin") and password ("Admin").
c. Click Login.
4. Open the Interface Table page (Configuration tab > VoIP menu > Network > IP
Interfaces Table).

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English