AudioCodes Mediant 500L MSBR User Manual

User's Manual 21. SIP Definitions
Version 6.8 305 Mediant 500L MSBR
21 SIP Definitions
This section describes configuration of various SIP-related functionalities.
21.1 Configuring SIP Parameters
Many of the stand-alone SIP parameters associated with various features can be
configured in the following pages:

SIP General Parameters page: Provides SIP parameters for configuring general SIP
features. To access this page, use the following path: Configuration tab > VoIP menu
> SIP Definitions > General Parameters.

SIP Advanced Parameters page: Provides SIP parameters for configuring advanced
SIP features. To access this page, use the following path: Configuration tab > VoIP
menu > SIP Definitions > Advanced Parameters.
For a description of these parameters, refer to the section corresponding to the feature or
see ''Configuration Parameters Reference'' on page 779.
21.2 Configuring Registration Accounts
The Account table lets you configure up to 50 Accounts. An Account defines registration
information for registering and authenticating (digest) "served" Trunk Groups or IP Groups
(e.g., IP PBX) with a "serving" IP Group (e.g., ITSP). Registration information includes a
username, password, host name (AOR), and contact user name (AOR). The device
includes this information in the REGISTER message sent to the "serving" IP Group. Up to
10 Accounts can be configured per "served" Trunk Group or IP Group.
A "served" Trunk Group or IP Group can register to more than one "serving" IP Group (e.g.,
multiple ITSPs). This is done by configuring multiple entries in the Account table for the
same "served" Trunk Group or IP Group, but with different "serving" IP Groups, user
name/password, host name, and contact user values.
Note: If no match is found in the Account table for incoming or outgoing calls, the
username and password is taken from:
• FXS interfaces: Authentication table (see Configuring Authentication on page 489
per Port)
• 'UserName' and 'Password' parameters on the Proxy & Registration page
The following procedure describes how to configure Accounts in the Web interface. You
can also configure Accounts using the table ini file parameter, Account or CLI command,
configure voip > sip-definition account.
 To configure an Account:
1. Open the Account Table page (Configuration tab > VoIP menu > SIP Definitions >
Account Table).
2. Click Add; the following dialog box appears:

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English