AudioCodes Mediant 500L MSBR User Manual

User's Manual 306 Document #: LTRT-10466
Mediant 500L MSBR
3. Configure an account according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Once you have configured Accounts, you can register or un-register them, as described
below:
 To register or un-register an Account:
1. In the table, select the required Account entry row.
2. From the Action drop-down list, choose one of the following commands:
• Register to register the Account.
• Un-Register to un-register an Account.
To view Account registration status, see ''Viewing Registration Status'' on page 700.
If all trunks belonging to the Trunk Group are down, the device un-registers them. If any
trunk belonging to the Trunk Group is returned to service, the device registers them again.
This ensures, for example, that the Proxy does not send INVITEs to trunks that are out of
service.
If registration with an IP Group fails for all accounts of a specific Trunk Group that includes
all the channels in the Trunk Group, the Trunk Group is set to Out-Of-Service if the
OOSOnRegistrationFail parameter is set to 1 (see Proxy & Registration Parameters on
page 309).
Table 21-1: Account Table Parameter Descriptions
Parameter Description
Index Defines an index for the new table record.
Served Trunk Group
CLI: served-trunk-group
[Account_ServedTrunkGroup]
Defines the Trunk Group ID that you want to register and/or
authenticate.
 For Tel-to-IP calls, the served Trunk Group is the source Trunk
Group from where the call originated.
 For IP-to-Tel calls, the served Trunk Group is the Trunk Group ID
to where the call is sent.
Note: This parameter is applicable only to the Gateway application.
Served IP Group
CLI: served-ip-group
[Account_ServedIPGroup]
Defines the IP Group (e.g., IP-PBX) that you want to register and/or
authenticate.
Note: This parameter is applicable only to the SBC and .
Serving IP Group
CLI: serving-ip-group
Defines the IP Group to where the device sends the SIP REGISTER
requests (if enabled) for registration and authentication.

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English