AudioCodes Mediant 500L MSBR User Manual

User's Manual 228 Document #: LTRT-10466
Mediant 500L MSBR
18.4.2 Enabling LDAP-based Web/CLI User Login Authentication and
Authorization
The LDAP service can be used for authenticating and authorizing device management
users (Web and CLI), based on the user's login username and password (credentials). At
the same, it can also be used to determine users' management access levels (privileges).
Before you can configure LDAP-based login authentication, you must enable this type of
LDAP service, as described in the following procedure.
 To enable LDAP-based login authentication:
1. Open the Authentication Settings page (Configuration tab > System menu >
Management > Authentication Settings).
Figure 18-6: Authentication Settings Page - Enabling LDAP-based Login
2. Under LDAP Settings, from the 'Use LDAP for Web/Telnet Login' drop-down list,
select Enable.
3. Click Submit, and then reset the device with a burn-to-flash for your settings to take
effect.
18.4.3 Configuring LDAP Servers
The LDAP Configuration table lets you configure up to four LDAP servers. This table
defines the address and connectivity settings of the LDAP server. The LDAP server can be
configured for SIP-related queries (e.g., routing and manipulation) or LDAP-based
management user login authentication and authorization (username-password).
The following procedure describes how to configure an LDAP server in the Web interface.
You can also configure this using the table ini file parameter, LdapConfiguration or CLI
command, configure voip/ldap/ldap-configuration.
 To configure an LDAP server:
1. Open the LDAP Configuration Table page (Configuration tab > VoIP menu >
Services > LDAP > LDAP Configuration Table).
2. Click Add; the following dialog box appears:
Figure 18-7: LDAP Configuration Table - Add Record

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English