AudioCodes Mediant 500L MSBR User Manual

User's Manual 252 Document #: LTRT-10466
Mediant 500L MSBR
 To enable LCR:
1. Open the Routing Rule Groups Table page (Configuration tab > VoIP menu >
Services > Least Cost Routing > Routing Rule Groups Table).
2. Click Add; the following dialog box appears:
Figure 18-26: Routing Rule Groups Table - Add Record
3. Enable LCR according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 18-14: Routing Rule Groups Table Parameter Descriptions
Parameter Description
Index
[RoutingRuleGroups_Index]
Defines an index number for the new table record.
Note: Only one index entry can be configured.
LCR Enable
CLI: lcr-enable
[RoutingRuleGroups_LCREnabl
e]
Enables the LCR feature:
 [0] Disabled (default)
 [1] Enabled
LCR Call Length
CLI: lcr-call-length
[RoutingRuleGroups_LCRAvera
geCallLength]
Defines the average call duration (in minutes) and is used to
calculate the variable portion of the call cost. This is useful, for
example, when the average call duration spans over multiple
time bands. The LCR is calculated as follows: cost = call
connect cost + (minute cost * average call duration)
The valid value range is 0-65533. The default is 1.
For example, assume the following Cost Groups:
 "Weekend A": call connection cost is 1 and charge per
minute is 6. Therefore, a call of 1 minute cost 7 units.
 "Weekend_ B": call connection cost is 6 and charge per
minute is 1. Therefore, a call of 1 minute cost 7 units.
Therefore, for calls under one minute, "Weekend A" carries the
lower cost. However, if the average call duration is more than
one minute, then "Weekend B" carries the lower cost.
Default Cost
CLI: lcr-default-cost
[RoutingRuleGroups_LCRDefaul
tCost]
Determines whether routing rules in the Outbound IP Routing
table without an assigned Cost Group are considered a higher
cost or lower cost route compared to other matched routing
rules that are assigned Cost Groups.
 [0] Lowest Cost = If the device locates other matching LCR
routing rules, this routing rule is considered the lowest cost
route and therefore, it is selected as the route to use
(default.)
 [1] Highest Cost = If the device locates other matching LCR
routing rules, this routing rule is considered as the highest
cost route and therefore, is not used or used only if the other

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English