AudioCodes Mediant 500L MSBR User Manual

User's Manual 296 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description

[6] Route
 [7] Diversion
 [8] P-Associated-URI
 [9] P-Called-Party-ID
 [10] Contact
 [11] Referred-by
Notes:
 This parameter is applicable only when classification is done
according to the Classification table.
 If the configured SIP header does not exist in the incoming
INVITE message, the classification of the message to a source
IP Group fails.

If the device receives an INVITE as a result of a REFER request
or a 3xx response, then the incoming INVITE is routed
according to the Request-URI. The device identifies such
INVITEs according to a specific prefix in the Request-URI
header, configured by the SBCXferPrefix parameter. Therefore,
in this scenario, the device ignores this parameter setting.
Destination URI Input
CLI: dst-uri-input
[IPGroup_DestUriInput]
Defines the SIP header in the incoming INVITE to use as a call
matching characteristic based on destination URIs. The parameter
is used for classification and routing purposes. The device first
uses the parameter’s settings as a matching characteristic (input)
to classify the incoming INVITE to an IP Group (source IP Group)
in the Classification table. Once classified, the device uses the
parameter for routing the call. For example, if set to To, the URI in
the To header of the incoming INVITE is used as a matching
characteristic for classifying the call to an IP Group in the
Classification table. Once classified, the device uses the URI in the
To header as the destination.
 [-1] Not Configured (default)
 [0] From
 [1] To
 [2] Request-URI
 [3] P-Asserted - First Header
 [4] P-Asserted - Second Header
 [5] P-Preferred
 [6] Route
 [7] Diversion
 [8] P-Associated-URI
 [9] P-Called-Party-ID
 [10] Contact
 [11] Referred-by
Notes:
 The parameter is applicable only when classification is done
according to the Classification table.
 If the configured SIP header does not exist in the incoming
INVITE message, the classification of the message to a source
IP Group fails.

If the device receives an INVITE as a result of a REFER request
or a 3xx response, then the incoming INVITE is routed
according to the Request-URI. The device identifies such
INVITEs according to a specific prefix in the Request-URI

AudioCodes Mediant 500L MSBR Specifications

General

Number of Ports	8
VoIP Support	Yes
VoIP Protocols	SIP, H.323, MGCP
Fax Support	T.38, G.711 pass-through
Management	Web-based, CLI, SNMP
Humidity	10% to 90% non-condensing
Product Type	MSBR
Form Factor	Rack-mountable
WAN Interfaces	4x 10/100/1000 Ethernet
LAN Interfaces	4x 10/100/1000 Ethernet
Power Supply	AC 100-240V
Redundancy	Optional power supply
Operating Temperature	0°C to 40°C