User's Manual 780 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
SNMP
CLI: wan-snmp-allow
[AllowWanSNMP]
Enables WAN access to the management interface through SNMP.
 [0] Disable (default)
 [1] Enable
 By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you must
also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable
Telnet
CLI: wan-telnet-allow
[AllowWanTelnet
Enables WAN access to the management interface through Telnet.
 [0] Disable (default)
 [1] Enable
 By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you must
also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable
SSH
CLI: wan-ssh-allow
[AllowWanSSH]
Enables WAN access to the management interface through SSH.
 [0] Disable (default)
 [1] Enable
 By default, the device's data-router firewall blocks all ("any")
incoming traffic on the WAN. Thus, to enable WAN access, you must
also enable the data-router firewall:
# configure data
(config-data)# interface gigabitethernet 0/0
(conf-if-GE 0/0)# firewall enable
Web: Web and Telnet
Access List Table
EMS: Web Access
Addresses
[WebAccessList_x]
This table configures up to ten IP addresses that are permitted to
access the device's Web interface and Telnet interfaces. Access from
an undefined IP address is denied. When no IP addresses are defined
in this table, this security feature is inactive (i.e., the device can be
accessed from any IP address).
The default is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of this parameter, see ''Configuring Web and Telnet
Access List'' on page 73.
To Next Page
Loading...
Need help?
General
