AudioCodes Mediant 500L MSBR User Manual

User's Manual 782 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description

[1] = Enable
[EnableMgmtTwoFactorAuthenti
cation]
Enables Web login authentication using a third-party, smart
card.
 [0] = Disable (default)
 [1] = Enable
When enabled, the device retrieves the Web user’s login
username from the smart card, which is automatically displayed
(read-only) in the Web
Login screen; the user is then required to
provide only the login password.
Typically, a TLS connection is established between the smart
card and the device’s Web interface, and a RADIUS server is
implemented to authenticate the password with the username.
Thus, this feature implements a two-factor authentication - what
the user has (the physical card) and what the user knows (i.e.,
the login password).
EMS: HTTPS Port
CLI: http-port
[HTTPport]
Defines the LAN HTTP port for Web management (default is
80). To enable Web management from the LAN, configure the
desired port.
Note: For this parameter to take effect, a device reset is
required.
EMS: Disable WEB Config
[DisableWebConfig]
Determines whether the entire Web interface is read-only.
 [0] = (Default) Enables modifications of parameters.
 [1] = Web interface is read-only.
When in read-only mode, parameters can't be modified. In
addition, the following pages can't be accessed: 'Web User
Accounts', 'Certificates', 'Regional Settings', 'Maintenance
Actions' and all file-loading pages ('Load Auxiliary Files',
'Software Upgrade Wizard', and 'Configuration File').
Notes:
 For this parameter to take effect, a device reset is required.
[ResetWebPassword]
Resets the username and password of the primary ("Admin")
and secondary ("User") accounts to their default settings
("Admin" and "Admin" respectively), and deletes all other users
that may have been configured.
 [0] = (Default) Password and username retain their values.
 [1] = Password and username are reset.
Notes:
 For this parameter to take effect, a device reset is required.
 You cannot reset the username and password through the
Web interface (by loading an ini file or on the AdminPage).
To reset the username and password:

SNMP:
1) Set acSysGenericINILine to
WEBPasswordControlViaSNMP = 1, and reset the
device with a flash burn (set
acSysActionSetResetControl to 1 and
acSysActionSetReset to 1).
2) Change the username and password in the
acSysWEBAccessEntry table. Use the following format:
Username acSysWEBAccessUserName: old/pass/new
Password acSysWEBAccessUserCode:

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English