AudioCodes Mediant 500L MSBR User Manual

User's Manual 67. Configuration Parameters Reference
Version 6.8 805 Mediant 500L MSBR
Parameter Description
[LifeLineType] Defines the condition(s) upon which the Lifeline analog (FXS)
feature is activated. The Lifeline feature can be activated upon a
power outage or network failure (i.e., loss of IP connectivity). Upon
any of these conditions, the Lifeline feature provides PSTN
connectivity and thus call continuity for the FXS phone users.
If the device is in Lifeline mode and the scenario that caused it to
enter Lifeline (e.g., power outage) no longer exists (e.g., power
returns), the device exists Lifeline and operates as normal.
 [0] = (Default) Lifeline is activated upon power outage.
 [1] = Lifeline is activated upon power outage.
 [2] = Lifeline is activated upon a power outage network failure
(logical link disconnection), or when the Trunk Group is in Busy
Out state (see the EnableBusyOut parameter).
The Lifeline (FXS) phone is connected to the following port:
 FXS Port 1
FXS Port 1 connects to the POTS (Lifeline) phone as well as to the
PSTN / PBX, using a splitter cable.
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only to FXS interfaces.
 To enable Lifeline upon network failure, the LAN Watchdog
feature must be activated (see the EnableLANWatchDog
parameter).
 For information on Lifeline cabling, refer to the Installation
Manual.
Web: Delay After Reset [sec]
CLI: delay-after-reset
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems cau
sed by
some LAN routers or IP configuration parameters' modifications by
a DHCP server.
[EnableAutoRAITransmitBER]
Enables the device to send a remote alarm indication (RAI) when
the bit error rate (BER) is greater than 0.001.
 [0] Disable (default)

[1]
Enable
Web: Ignore BRI LOS Alarm
CLI: ignore-bri-los-alarm
[IgnoreBRILOSAlarm]
Enables the device to ignore LOS alarms received from the BRI
user-side trunk and attempts to make a call (relevant for IP-to-Tel
calls).
 [0] Disable
 [1] Enable (default)
Note: This parameter is applicable only to BRI interfaces.

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English