AudioCodes Mediant 500L MSBR User Manual

User's Manual 67. Configuration Parameters Reference
Version 6.8 913 Mediant 500L MSBR
Parameter Description
Call Forwarding Table
Web: Call Forwarding
Table
EMS: Analog Gateway
Provisioning > Tab: Call
Forward
CLI: configure voip > gw
analoggw call-forward
[FwdInfo]
This table parameter configures call forwarding of IP-to-Tel calls (using
SIP 302 response) to other device ports or an IP destination, based on
the device's port to which the call was originally routed.
The format of the ini file table parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Module, FwdInfo_Port;
[\FwdInfo]
Where,
 Module = Module number, where 1 denotes the module in Slot 1.
 Port = Port number, where 1 denotes Port 1 of a module.
For example:
 Below configuration forwards calls originally destined to Port 1 of
Module 1 to "1001" upon On Busy:
FwdInfo 0 = 1,1001,30,1,1;
 Below configuration forwards calls originally destined to Port 2 of
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
For a detailed description of this table, see Configuring Call Forward on
page 493.
Note: This parameter is applicable only to FXS and FXO interfaces.
Call Forward Reminder Ring Parameters
Notes:
 These parameters are applicable only to FXS interfaces.
 For a description of this feature, see Call Forward Reminder Ring on page 441.
Web/EMS: Enable NRT
Subscription
CLI: nrt-subscription
[EnableNRTSubscription]
Enables endpoint subscription for Ring reminder event notification
feature.
 [0] Disable (default)
 [1] Enable
Web: AS Subscribe
IPGroupID
CLI: as-subs-ipgroupid
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).
Web: NRT Retry
Subscription Time
EMS: NRT Subscription
Retry Time
[NRTSubscribeRetryTime]
Defines the Retry period (in seconds) for Dialog subscription if a previous
request failed.
The valid value range is 10 to 7200. The default is 120.
Web/EMS: Call Forward
Ring Tone ID
CLI: cfe-ring-tone-id
[CallForwardRingToneID]
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.

AudioCodes Mediant 500L MSBR Specifications

General

Brand	AudioCodes
Model	Mediant 500L MSBR
Category	Network Router
Language	English