User's Manual 67. Configuration Parameters Reference
Version 6.8 915 Mediant 500L MSBR
Parameter Description
Web/EMS: MWI Server Transport
Type
CLI: mwi-srvr-transp-type
[MWIServerTransportType]
Determines the transport layer used for outgoing SIP dialogs
initiated by the device to the MWI server.
ï‚§ [-1] Not Configured (default)
ï‚§ [0] UDP
ï‚§ [1] TCP
ï‚§ [2] TLS
Note: When set to ‘Not Configured’, the value of the parameter
SIPTransportType is used.
Web: MWI Subscribe Expiration
Time
EMS: MWI Expiration Time
CLI: mwi-subs-expr-time
[MWIExpirationTime]
Defines the MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 2,000,000.
Web: MWI Subscribe Retry Time
EMS: Subscribe Retry Time
CLI: mwi-subs-rtry-time
[SubscribeRetryTime]
Defines the subscription retry time (in seconds) after last
subscription failure.
The default is 120 seconds. The range is 10 to 2,000,000.
Web: Subscription Mode
CLI: subscription-mode
[SubscriptionMode]
Determines the method the device uses to subscribe to an MWI
server.
ï‚§ [0] Per Endpoint = (Default) Each endpoint subscribes
separately - typically used for FXS interfaces.
ï‚§ [1] Per Gateway = Single subscription for the entire device -
typically used for FXO interfaces.
EMS: ETSI VMWI Type One
Standard
CLI: etsi-vmwi-type-one-standard
[ETSIVMWITypeOneStandard]
Determines the ETSI Visual Message Waiting Indication
(VMWI) Type 1 sub-standard.
ï‚§ [0] = (Default) ETSI VMWI between rings
ï‚§ [1] = ETSI VMWI before ring DT_AS
ï‚§ [2] = ETSI VMWI before ring RP_AS
ï‚§ [3] = ETSI VMWI before ring LR_DT_AS
ï‚§ [4] = ETSI VMWI not ring related DT_AS
ï‚§ [5] = ETSI VMWI not ring related RP_AS
ï‚§ [6] = ETSI VMWI not ring related LR_DT_AS
Note: For this parameter to take effect, a device reset is
required.
EMS: Bellcore VMWI Type One
Standard
CLI: bellcore-vmwi-type-one-
standard
[BellcoreVMWITypeOneStandard]
Determines the Bellcore VMWI sub-standard.
ï‚§ [0] = (Default) Between rings.
ï‚§ [1] = Not ring related.
Note: For this parameter to take effect, a device reset is
required.