Cisco ASA Series User Manual

1-11
Cisco ASA Series ASDM Configuration Guide
Chapter 1 Configuring the Switch for Use with the ASA Services Module
Resetting the ASA Services Module
Resetting the ASA Services Module
This section describes how to reset the ASASM. You might need to reset the ASASM if you cannot reach
it through the CLI or an external Telnet session. The reset process might take several minutes.
Detailed Steps
Examples
The following is sample output from the hw-module module reset command:
Router# hw-module module 9 reset
Proceed with reload of module? [confirm] y
% reset issued for module 9
Router#
00:26:55:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:26:55:SP:The PC in slot 8 is shutting down. Please wait ...
Monitoring the ASA Services Module
To monitor the ASA, enter one of the following commands:
Examples
The following is sample output from the show firewall module [mod-num] state command:
Command Purpose
hw-module [switch {1 |2}] module slot reset
Example:
Router# hw-module module 9 reset
Resets the ASASM.
For a switch in a VSS, enter the switch argument.
The slot argument indicates the slot number in which the
module is installed. To view the slots where the ASASM is
installed, enter the show module command.
Note To reset the ASASM when you are already logged in
to it. enter either the reload or reboot command.
Command Purpose
show firewall module [mod-num] state
Verifies the state of the ASA.
show firewall module [mod-num] traffic
Verifies that traffic is flowing through the ASA.
show firewall module [mod-num] version
Shows the software version of the ASA.
show firewall multiple-vlan-interfaces
Indicates the status of multiple VLAN interfaces (enabled or
disabled).
show firewall vlan-group
Displays all configured VLAN groups.
show interface vlan
Displays the status and information about the configured
VLAN interface.

Cisco ASA Series Specifications

General

Brand	Cisco
Model	ASA Series
Category	Network Hardware
Language	English