Cisco ASA Series User Manual

1-8
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring NetFlow Secure Event Logging (NSEL)
Configuring NSEL
What to Do Next
See the “Disabling and Reenabling NetFlow-related Syslog Messages” section on page 1-8.
Disabling and Reenabling NetFlow-related Syslog Messages
To disable and reenable NetFlow-related syslog messages, perform the following steps:
What to Do Next
See the “Clearing Runtime Counters” section on page 1-8.
Clearing Runtime Counters
To reset runtime counters, enter the following command:
Command Purpose
Step 1
logging flow-export-syslogs disable
Example:
hostname(config)# logging flow-export-syslogs
disable
Disables syslog messages that have become
redundant because of NSEL.
Note Although you execute this command in
global configuration mode, it is not stored in
the configuration. Only the no logging
message xxxxxx commands are stored in the
configuration.
Step 2
logging message xxxxxx
Example:
hostname(config)# logging message 302013
Reenables syslog messages individually, where
xxxxxx is the specified syslog message that you want
to reenable.
Step 3
logging flow-export-syslogs enable
Example:
hostname(config)# logging flow-export-syslogs enable
Reenables all NSEL events at the same time.
Command Purpose
clear flow-export counters
Example:
hostname# clear flow-export counters
Resets all runtime counters for NSEL to zero.

Cisco ASA Series Specifications

General

Brand	Cisco
Model	ASA Series
Category	Network Hardware
Language	English