EasyManuals Logo
Home>Cisco>Network Hardware>ASA Series

Cisco ASA Series User Manual

Cisco ASA Series
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1151 background imageLoading...
Page #1151 background image
1-9
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Inspection for Voice and Video Protocols
H.323 Inspection
hostname(config-h225-map-hsi-grp)# hsi ip_address
Where ip_address is the host to add. A maximum of five hosts per hsi group are allowed.
To add an endpoint to the hsi group, enter the following command in hsi group configuration
mode:
hostname(config-h225-map-hsi-grp)# endpoint ip_address if_name
Where ip_address is the endpoint to add and if_name is the interface through which the endpoint
is connected to the security appliance. A maximum of ten endpoints per hsi group are allowed.
g. To check RTP packets flowing on the pinholes for protocol conformance, enter the following
command:
hostname(config-pmap-p)# rtp-conformance [enforce-payloadtype]
Where the enforce-payloadtype keyword enforces the payload type to be audio or video based on
the signaling exchange.
h. To enable state checking validation, enter the following command:
hostname(config-pmap-p)# state-checking {h225 | ras}
The following example shows how to configure phone number filtering:
hostname(config)# regex caller 1 “5551234567”
hostname(config)# regex caller 2 “5552345678”
hostname(config)# regex caller 3 “5553456789”
hostname(config)# class-map type inspect h323 match-all h323_traffic
hostname(config-pmap-c)# match called-party regex caller1
hostname(config-pmap-c)# match calling-party regex caller2
hostname(config)# policy-map type inspect h323 h323_map
hostname(config-pmap)# parameters
hostname(config-pmap-p)# class h323_traffic
hostname(config-pmap-c)# drop
Configuring H.323 and H.225 Timeout Values
To configure the idle time after which an H.225 signalling connection is closed, use the timeout h225
command. The default for H.225 timeout is one hour.
To configure the idle time after which an H.323 control connection is closed, use the timeout h323
command. The default is five minutes.
Verifying and Monitoring H.323 Inspection
This section describes how to display information about H.323 sessions. This section includes the
following topics:
Monitoring H.225 Sessions, page 1-10
Monitoring H.245 Sessions, page 1-10
Monitoring H.323 RAS Sessions, page 1-11

Table of Contents

Other manuals for Cisco ASA Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA Series and is the answer not in the manual?

Cisco ASA Series Specifications

General IconGeneral
BrandCisco
ModelASA Series
CategoryNetwork Hardware
LanguageEnglish

Related product manuals