Cisco ASA Series User Manual

1-2
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Static and Default Routes
Licensing Requirements for Static and Default Routes
syslog server, Websense or N2H2 server, or AAA server. If you have servers that cannot all be reached
through a single default route, then you must configure static routes. Additionally, the ASA supports up
to three equal cost routes on the same interface for load balancing.
Licensing Requirements for Static and Default Routes
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
IPv6 Guidelines
Supports IPv6.
Failover Guidelines
Supports Stateful Failover of dynamic routing protocols.
Additional Guidelines
• IPv6 static routes are not supported in transparent mode in ASDM.
• In clustering, static route monitoring is only supported on the master unit. For information about
clustering, see Chapter 1, “Configuring a Cluster of ASAs.”
Configuring Static and Default Routes
This section explains how to configure a static route and a static default route and includes the following
topics:
• Configuring a Static Route, page 1-3
• Configuring a Default Static Route, page 1-4
• Configuring IPv6 Default and Static Routes, page 1-5
Model License Requirement
All models Base License.

Cisco ASA Series Specifications

General

Brand	Cisco
Model	ASA Series
Category	Network Hardware
Language	English