Cisco ASA Series User Manual

1-28
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring SNMP
Configuration Examples for SNMP
0 Set-request PDUs (Not supported)
0 SNMP packets output
0 Too big errors (Maximum packet size 512)
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
The following example shows how to display the SNMP server running configuration:
hostname(config)# show running-config snmp-server
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
Configuration Examples for SNMP
This section includes the following topics:
• Configuration Example for SNMP Versions 1 and 2c, page 1-28
• Configuration Example for SNMP Version 3, page 1-28
Configuration Example for SNMP Versions 1 and 2c
The following example shows how the ASA can receive SNMP requests from host 192.0.2.5 on the
inside interface but does not send any SNMP syslog requests to any host:
hostname(config)# snmp-server host 192.0.2.5
hostname(config)# snmp-server location building 42
hostname(config)# snmp-server contact EmployeeA
hostname(config)# snmp-server community ohwhatakeyisthee
Configuration Example for SNMP Version 3
The following example shows how the ASA can receive SNMP requests using the SNMP Version 3
security model, which requires that the configuration follow this specific order: group, followed by user,
followed by host:
hostname(config)# snmp-server group v3 vpn-group priv
hostname(config)# snmp-server user admin vpn group v3 auth sha letmein priv 3des cisco123
hostname(config)# snmp-server host mgmt 10.0.0.1 version 3 priv admin

Cisco ASA Series Specifications

General

Brand	Cisco
Model	ASA Series
Category	Network Hardware
Language	English