Cisco ASA Series User Manual

1-11
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Network Object NAT
Configuring Network Object NAT
The following example configures dynamic PAT with a PAT pool to translate the inside IPv6 network to
an outside IPv4 network:
hostname(config)# object network IPv4_POOL
hostname(config-network-object)# range 203.0.113.1 203.0.113.254
hostname(config)# object network IPv6_INSIDE
hostname(config-network-object)# subnet 2001:DB8::/96
hostname(config-network-object)# nat (inside,outside) dynamic pat-pool IPv4_POOL
Configuring Static NAT or Static NAT-with-Port-Translation
This section describes how to configure a static NAT rule using network object NAT. For more
information, see the “Static NAT” section on page 1-3.
Detailed Steps
Command Purpose
Step 1
(Optional) Create a network object or group for
the mapped addresses.
See the “Adding Network Objects for Mapped Addresses” section
on page 1-4.
Step 2
object network obj_name
Example:
hostname(config)# object network
my-host-obj1
Configures a network object for which you want to configure
NAT, or enters object network configuration mode for an existing
network object.

Cisco ASA Series Specifications

General

Brand	Cisco
Model	ASA Series
Category	Network Hardware
Language	English