Cisco ASA Series User Manual

1-52
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Connection Profiles, Group Policies, and Users
Group Policies
hostname(config-group-policy)#
Step 2 Configure the the time at which a session-timeout alert message is displayed to the user using the
vpn-session-timeout alert-interval {minutes | none} command. This alert message tells users how
many minutes left they have until their VPN session is automatically disconnected.
The following example shows how to set the
vpn-session-timeout alert-interval so that users will
be notified 20 minutes before their VPN session is disconnected. You can specify a range of 1-30
minutes.
hostname(config-webvpn)# vpn-session-timeout alert-interval 20
The none parameter indicates that users will not receive an alert.
Use the no form of the command to indicate that the VPN session timeout alert-interval attribute will be
inherited from the Default Group Policy:
no vpn-session-timeout alert-interval
Specifying a VPN Session Idle Timeout for a Group Policy
Step 1 Configure the user timeout period by entering the vpn-idle-timeout command in group-policy
configuration mode or in username configuration mode:
hostname(config-group-policy)# vpn-idle-timeout {minutes | none}
hostname(config-group-policy)#
AnyConnect (SSL IPsec/IKEv2): Use the global WebVPN default-idle-timeout value (seconds) from the
command: hostname(config-webvpn)# default-idle-timeout
The range for this value in the WebVPN default-idle-timeout command is 60-86400 seconds; the
default Global WebVPN Idle timeout in seconds -- default is 1800 seconds (30 min).
Note A non-zero idle timeout value is required by ASA for all AnyConnect connections.
For a WebVPN user, the default-idle-timeout value is enforced only if vpn-idle-timeout none is set in
the group policy/username attribute.
Site-to-Site (IKEv1, IKEv2) and IKEv1 remote-access: Disable timeout and allow for an unlimited idle
period.
The following example shows how to set a VPN idle timeout of 15 minutes for the group policy named
FirstGroup:
hostname(config)# group-policy FirstGroup attributes
hostname(config-group-policy)# vpn-idle-timeout 15
hostname(config-group-policy)#
Step 2 Configure the the time at which an idle-timeout alert message is displayed to the user using the
vpn-idle-timeout alert-interval {minutes | none}
command. This alert message tells users how many
minutes left they have until their VPN session is disconnected due to inactivity.
The following example shows how to set vpn-idle-timeout alert-interval so that users will be notified 20
minutes before their VPN session is disconnected due to inactivity. You can specify a range of 1-30
minutes.
hostname(config-webvpn)# vpn-idle-timeout alert-interval 20
The none parameter indicates that users will not receive an alert.

Cisco ASA Series Specifications

General

Brand	Cisco
Model	ASA Series
Category	Network Hardware
Language	English