4.2.3 Device Installation Process
This section describes the general device installation process. Before installing
device, you need to determine the installation mode according to installation
environment. After unpacking and inspecting the device, you need to install the
chassis,
bers and cables in sequence, and then check the installation result. After
determining that the installation is correct, you can power on the device and then
check ber connections.
Table 4-50 lists the general installation process.
Table 4-50 Device installation process
Installation Process Description
Preparing for the
installation
Before installing a device, plan and construct the
installation space and conrm the installation method
based on the requirements of device operation
environment. This is a prerequisite for smooth
installation, commissioning, and stable running of the
device. For details, see section Preparing for the
Installation in
Hardware Installation and Maintenance
.
Unpacking a device After the project starts, the project supervisor should
unpack and check the device together with the customer
representative. For details, see section Unpacking a
Device in
Hardware Installation and Maintenance
.
Installing a chassis The installation method of the chassis varies according
to the installation environment. For details, see section
Installing a Chassis in
Hardware Installation and
Maintenance
.
Installing
components
Generally, the components are installed in the chassis. If
the components are delivered separately, see section
Installing Components in
Hardware Installation and
Maintenance
.
Planning cable
routing
To ensure that power cables are connected in order, you
are advised to plan power cable routing. For details, see
section Planning Cable Routing in
Hardware Installation
and Maintenance
.
Installing cables The methods of installing cables vary according to the
installation environment of the chassis. For details, see
section Installing Cables in
Hardware Installation and
Maintenance
.
Checking the
installation
To ensure normal and stable running of a device, you
need to check the installation of the device after all
hardware is installed. For details, see section Post-
Installation Check in
Hardware Installation and
Maintenance
.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 573
To Next Page
Loading...
Need help?
General
