c. Press the spring pin with your nger and push the upper part of the door
till the spring pin properly inserts in the installation hole at the top of the
lintel.
d. Check the spring pin and lower pins and ensure that the door is properly
installed.
e. Follow the same steps to install the rear door.
Figure 4-33 Installing the cabinet doors
2. Installing the ground cables at the front doors and rear doors as shown in the
gure.
Figure 4-34 Installing the ground cables
4.1.3 Device Installation Process
This section describes the general device installation process. Before installing
device, you need to determine the installation mode according to installation
environment. After unpacking and inspecting the device, you need to install the
chassis, boards,
bers, and cables in sequence, and then check the installation
result. After determining that the installation is correct, you can power on the
device and then check
ber connections.
Table 4-4 lists the general installation process.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 373
To Next Page
Loading...
Need help?
General
