CHAPTER 13
Installing the Mounting Hardware
•
Preparing the SRX550 High Memory Services Gateway for Rack-Mount
Installation on page 95
•
Connecting the SRX550 High Memory Services Gateway to the Building
Structure on page 96
Preparing the SRX550 High Memory Services Gateway for Rack-Mount Installation
You can mount an SRX550 High Memory Services Gateway on four-post (telco) racks,
enclosed cabinets, and open-frame racks. Center-mount racks are not supported.
Before mounting the SRX550 High Memory Services Gateway in a rack:
•
Verify that the site meets the requirements described in “Site Preparation Checklist
for the SRX550 High Memory Services Gateway” on page 47.
•
Verify that you have the following parts available in your rack-mounting kit for the
SRX550 High Memory Services Gateway:
•
Rack-mounting brackets
•
Eight mounting screws to attach the mounting brackets to the chassisof the services
gateway
•
Four mounting screws to attach the mounting brackets to the rack rail
•
Verify that the racks or cabinets meet the specific requirements described in “SRX550
High Memory Services Gateway Rack Size and Strength Requirements” on page 57.
•
Place the rack or cabinet in its permanent location, allowing adequate clearance for
airflow and maintenance, and secure it to the building structure. For more information,
see “SRX550 High Memory Services Gateway Cabinet Airflow Requirements” on
page 62.
•
Remove the gateway chassis from the shipping carton. For unpacking instructions, see
“Unpacking the SRX550 High Memory Services Gateway” on page 91.
Related
Documentation
SRX550 High Memory Services Gateway Cabinet Size and Clearance Requirements
on page 61
•
• Installation Overview for the SRX550 High Memory Services Gateway on page 87
95Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
