To configure the modem on the services gateway end:
1. Connect the modem to the management device (a desktop or laptop computer).
2. Power on the modem.
3. From the management device, start your asynchronous terminal emulation application
(such as Microsoft Windows HyperTerminal), and select the COM port to which the
modem is connected (for example, COM1).
4. Configure the port settings, as listed in Table 51 on page 114.
Table 51: Port Settings
ValuePort Settings
9600Bits per second
8Data bits
NoneParity
1Stop bits
NoneFlow control
5. In the HyperTerminal window, type AT.
For more information on the AT commands, see the Installation and Upgrade Guide
for Security Devices.
An OK response verifies that the modem can communicate successfully with the COM
port on the management device.
6. To configure the modem to answer a call on the first ring, type ATS0=1.
7. To configure the modem to accept modem control DTR signals, type AT&D1.
8. To disable flow control, type AT&K0.
9. To save modem settings, type AT&W.
Related
Documentation
• Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
• Connecting the Modem to the Console Port on the SRX550 High Memory Services
Gateway on page 110
• Connecting the CLI at the User End for the SRX550 High Memory Services Gateway
on page 112
Copyright © 2016, Juniper Networks, Inc.114
SRX550 High Memory Services Gateway Hardware Guide
To Next Page
Loading...
Need help?
General
