Juniper SRX550 Hardware Guide

Troubleshooting with Chassis and Interface Alarm Messages on the SRX550 High
Memory Services Gateway
When the services gateway detects an alarm condition, it lights the red or yellow alarm
LED on the front panel as appropriate. For a detailed description of the alarm condition,
issue the show chassis alarms CLI command.
There are two classes of alarm messages:
•
Chassis alarms—Indicate a problem with a chassis component such as the cooling
system or power supply.
•
Interface alarms—Indicate a problem with a specific network interface.
For more information about the show chassis alarms command, see Monitoring and
Troubleshooting for Security Devices.
Table 59 on page 148 describes alarms that can occur for a services gateway chassis
component.
Table 59: Alarms for Services Gateway Chassis Components
Alarm SeverityActionAlarm ConditionsComponent
Yellow (minor)If the internal flash fails at
startup, the services
gateway automatically
boots itself from the
alternative boot device
(USB storage device).
If you configured your
services gateway to boot
from an alternative boot
device, ignore this alarm
condition.
If you did not configure the
services gateway to boot
from an alternative boot
device, contact JTAC.
The services gateway
boots from an
alternate boot device.
Boot media
Red (major)Contact JTAC.
See “Juniper Networks
Technical Assistance
Center” on page 155
A GPIM has failed.Gigabit-Backplane
Physical Interface
Module (GPIM)
Copyright © 2016, Juniper Networks, Inc.148
SRX550 High Memory Services Gateway Hardware Guide

Juniper SRX550 Specifications

General

Brand	Juniper
Model	SRX550
Category	Gateway
Language	English