For example, if someone inadvertently commits a configuration that denies management
access to a services gateway, you can delete the invalid configuration and replace it with
a rescue configuration by pressing the RESET CONFIG button. You must have previously
set the rescue configuration through the J-Web interface or the CLI. The rescue
configuration is a previously committed, valid configuration.
CAUTION: Pressing and holding the RESET CONFIG button for 15 seconds
or more—until the STATUS LED blinks red—deletes all configurations on the
services gateway, including the backup configurations and rescue
configuration, and loads and commits the factory configuration.
There are two types of reset:
•
Power On—This reset occurs during the services gateway powering on and powering
off. This reset is issued when the services gateway is first powered on. The system
accesses the configuration settings from the boot flash for this type of reset.
•
Config—This reset is the asynchronous reset input to the services gateway. The RESET
CONFIG button is used to generate a reset to load the default configuration settings
from the kernel. The system accesses the default factory settings from the internal
flash for this type of reset.
Related
Documentation
Grounding the SRX550 High Memory Services Gateway on page 106•
• Powering On the SRX550 High Memory Services Gateway on page 120
• Powering Off the SRX550 High Memory Services Gateway on page 120
• SRX550 High Memory Services Gateway Front Panel on page 14
Juniper Networks Technical Assistance Center
If you need assistance while troubleshooting a services gateway, open a support case
using the Case Manager link at http://www.juniper.net/support/, or call 1-888-314-JTAC
(within the United States) or 1-408-745-9500 (outside the United States).
Related
Documentation
• Return Procedure for the SRX550 High Memory Services Gateway on page 180
• Verifying Parts Received with the SRX550 High Memory Services Gateway on page 92
155Copyright © 2016, Juniper Networks, Inc.
Chapter 20: Troubleshooting Components
To Next Page
Loading...
Need help?
General
