• SRX550 High Memory Services Gateway Front Panel on page 14
• Troubleshooting with Chassis and Interface Alarm Messages on the SRX550 High
Memory Services Gateway on page 148
• Changing the RESET CONFIG Button Behavior on the SRX550 High Memory Services
Gateway on page 154
Using the RESET CONFIG Button on the SRX550 High Memory Services Gateway
If a configuration fails or denies management access to the services gateway, you can
use the RESET CONFIG button to restore the services gateway to the factory-default
configuration or a rescue configuration. For example, if someone inadvertently commits
a configuration that denies management access to a services gateway, you can delete
the invalid configuration and replace it with a rescue configuration by pressing the RESET
CONFIG button. The button is recessed to prevent it from being pressed accidentally.
The rescue configuration is a previously committed, valid configuration. You must have
previously set the rescue configuration through the J-Web interface or the CLI.
To press the RESET CONFIG button, insert a small probe (such as a straightened paper
clip) into the pinhole on the front panel.
CAUTION:
By default, pressing and quickly releasing the RESET CONFIG button loads
and commits the rescue configuration through the J-Web interface or the
CLI. (For details, see the CLI Explorer.)
•
•
By default, pressing and holding the RESET CONFIG button for 15 seconds
or more—until the STATUS LED blinks red—deletes all configurations on
the services gateway, including the backup configurations and rescue
configuration, and loads and commits the factory configuration.
For details about factory-default settings, see “Viewing Factory-Default Settings of the
SRX550 High Memory Services Gateway” on page 128.
Related
Documentation
Troubleshooting with the CLI on the SRX550 High Memory Services Gateway on page 145•
• Troubleshooting with LEDs on the SRX550 High Memory Services Gatewayon page 146
• SRX550 High Memory Services Gateway Front Panel on page 14
• Troubleshooting with Chassis and Interface Alarm Messages on the SRX550 High
Memory Services Gateway on page 148
• Changing the RESET CONFIG Button Behavior on the SRX550 High Memory Services
Gateway on page 154
• Troubleshooting the Power System on the SRX550 High Memory Services Gateway
on page 150
• Resetting the SRX550 High Memory Services Gateway on page 154
153Copyright © 2016, Juniper Networks, Inc.
Chapter 20: Troubleshooting Components
To Next Page
Loading...
Need help?
General
