CHAPTER 18
Performing Initial Configuration
•
SRX550 High Memory Services Gateway Basic Connectivity Overview on page 123
•
Built-In Ethernet Ports for the SRX550 High Memory Services Gateway on page 124
•
Management Access for the SRX550 High Memory Services Gateway on page 127
•
Viewing Factory-Default Settings of the SRX550 High Memory Services
Gateway on page 128
•
SRX550 High Memory Services Gateway Secure Web Access Overview on page 128
•
Configuring the SRX550 High Memory Services Gateway Using J-Web on page 129
•
Connecting to the SRX550 High Memory Services Gateway from the CLI
Locally on page 131
•
Connecting to the SRX550 High Memory Services Gateway from the CLI
Remotely on page 133
•
Configuring the SRX550 High Memory Services Gateway Using the CLI on page 134
•
Configuring Gigabit-Backplane Physical Interface Modules on page 136
•
Configuring Mini-Physical Interface Modules on page 137
SRX550 High Memory Services Gateway Basic Connectivity Overview
The Juniper Networks Junos operating system (Junos OS) is preinstalled on the SRX550
High Memory Services Gateway. When the services gateway is powered on, it is ready to
be configured.
If you are setting up a services gateway for the first time, you can use the command-line
interface (CLI) and the J-Web interface to configure basic connectivity .
If you are setting up many services gateways, autoinstallation can help automate the
configuration process. See “SRX550 High Memory Services Gateway Autoinstallation
Overview” on page 89.
Before you configure the services gateway for the first time, you must complete the
prerequisite tasks listed in Table 52 on page 124.
123Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
